Day 396: The wee cabinet in the corner

Corners are not just for naughty children anymore - cabinets can go in there too. Children can also go in corner cabinets, but that isn't advised.

So this weekend's dilemma was how to fit a fridge and hopefully a somewhat usable cabinet space in a short span of wall. We found some rather slim, but tall 400mm cabinets that should do the trick.

First, I put in some supports onto the wall to hold the countertop.

Next came the base cabinet. This was fixed to the wall using the support and some corner brackets. A bit more stone cladding on the right side to make every thing look tidy.

A countertop was then cut using some of the leftovers from the breakfast bar. There wasn't much material remaining to use, so once again, very little room for missed cuts.The cabinet mounts were then placed on the wall with care .. and some brick dust .. cough. 

And the tall cabinet fit snugly against the wall .. completely level of course.

Now with the doors on and the wee microwave we ordered to just fit the gap. 

Next some pelmet action. Think I was spending more time by now taking photos than doing any real work ... oh well

And some more stone cladding ... I elected to do this after installing the pelmet so that I could measure the exact size needed (much better than trying to add).

And finally I closed things off with a door. Sorry bad daddy humour; builder humour unfortunately can't be printed on a PG rated website.

A little nifty work was required to finish off that small gap between the base cabinet and the wall. I put 2 pieces of cladding together at a right angle so that I could fasten it without any screws being visible from out outside. The wider edge was then screwed from the inside of the cabinet. Very nifty.

 

And the (almost) finished product. I just need to do a bit of cornice work at the top to make things look pretty. So we managed to squeeze the fridge and a somewhat useable cabinet into a very small space in the corner. More great things are planned for this cabinet, but that will be the subject of a future post... stay tuned.Just need to now find a new corner to put the naughty kids ...

Day 382: Getting stoned

With the Great Peninsula of Surbiton firmly fixed, on came the stone colour match cladding. 

This was generally pretty easy to do. Measure the gap, tape the ends and cut to length. I used my squeeze grips to hold in place and fixed with 30mm wood screws.

The back was a bit more tricky as there was a gap between the back of the cabinet and the cladding. So I had 2 options: 1) screw it on from the front and have the screws visible (the lazy way) or 2) find a way of fixing the panel from the back.Fearing that I'd risk losing my loyal following to this blog (a cast of millions) and be subject to the "your screw is showing" criticisms at home - I opted for the more challenging option. I put some wood to bridge the space and some corner brackets on the bottom. I'm sure that there is probably a much easier way to do this, but I couldn't think of one. 

So there you go, my peninsula is now stoned and looking fine. The cladding makes a huge difference to the overall look of the cabinets. And for the record, none of my screws are showing.